Derive new 2nd floor plan from the 1st floor plan.Select Build> Floor> Build New Floor from the menu.If you build an additional floor above the first floor level, bear in mind that the ceiling heights on Floor 1 will be reset to the default. Select File> Close View to close the camera view and return to floor plan view.The Floor Overview updates to show the change that you made to the room.Press the Tab key and notice that the Stem Wall height increases to accommodate the new ceiling height.In this example, it is raised to 109 1/8". Increase the Rough Ceiling value so that the room is full height.Notice that the Stem Wall height value is equal to the Minimum Stem Wall Height that you specified in the Build Foundation dialog plus the height of the Floor of the room above.Click the Select Objects button, then click on an inside wall surface of the foundation room, below the part of the structure with the raised floor height (in this example, the left side).The stem walls under the area with the raised floor are taller but have the same footing height. Notice that the Minimum Stem Wall height is applied to the part of the structure with the lower, default floor height. While still on Floor 0, create a Doll House View to see what this foundation looks like.Make any other needed changes, then click OK, then OK again to close the dialog and modify the foundation on Floor 0.In this example, a height of 24" is used. Select Walls With Footings as the Foundation Type.Uncheck Automatically Rebuild Foundation.Select Build> Floor> Build Foundation from the menu to open the Build Foundation dialog.In a split level home, part of the foundation is typically a slab or crawl space and part is full height basement - often a daylight basement. With the wall selected, click the Reverse Layers edit button.The room will be selected first - press the Tab key or click the Select Next Object edit button to select the wall instead.If it does not, click the Select Objects button, then click on the wall.The wall that divides the structure into two halves should have its exterior siding surface facing the room with the lower floor height.Select 3D> Create Camera View> Doll House View to see the results so far.Click OK to close the dialog and apply your change.Check the Default box next to Rough Ceiling (E) and press the Tab key to restore a full height ceiling to this room.Press the Tab key on your keyboard to update the dialog and notice that the Relative Ceiling heights become smaller.In this example, this value is increased to 48". Click the Open Object edit button, and on the Structure panel of the Room Specification dialog:.In this example, the room on the left side is selected. Click the Select Objects button, then click in an empty space in one of the two room areas of your drawing to select it.Still using the Exterior Wall tool, draw a wall that divides the structure into two rooms.Select Build> Wall> Exterior Wall, then click and drag to draw a simple rectangular structure.Launch Home Designer and create a New Plan.You can easily create a split level in Home Designer by controlling the floor and ceiling heights of different rooms in a plan. How do I create a split level floor plan?Ī split level, sometimes referred to as a bi-level or tri-level, is a building where the floor level in one part of the structure is located about halfway between the floor and ceiling levels of another part of the structure. The information in this article applies to:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |